Energy storage cabinet exhaust fan installation diagram

How to install an exhaust fan?

The ideal fan installation has long sections of straight duct at fan inlet and outlet. all units are provided with rubber vibration isolator. Using a proper metal chassis for fixing the fan is strongly recommended. unit must be set level (A schematic drawing of exhaust fan fixing is shown in figure 2).

How do I install a power exhaust unit?

6. Place the power exhaust near the exhaust air opening in preparation for wiring to the unit. It may be easier to hold the power exhaust unit up to this opening and attach with a few screws and then remove so that the installation will be easier later when it is important that the wires are not pinched.

What should be considered when installing a fan?

Special attention should be made in fan installation. Improper installation will adversely affect fan and system performance resulting in increased energy consumption. This may also increase noise levels. The ideal fan installation has long sections of straight duct at fan inlet and outlet. all units are provided with rubber vibration isolator.

What information is included in the Enphase ensembletm energy management documents?

This document provides site surveyors and design engineers with the information required to evaluate a site and plan for the Enphase EnsembleTM energy management system. The information provided in the documents supplements the information in the data sheets, quick install guides and product manuals.

How do I install a power exhaust wire harness?

Install the power exhaust power wire harness into the pressure lugs on the compressor contactor, used for the field power wiring also. Follow all local and NEC (National Electrical Code) codes. If a single power source is to be used, size the wire to include power exhaust MCA and MOCP. (See Table 3.)

How do you install a fan?

If power assembly (motor, wheel, and scroll) is not installed in housing, insert the electrical plug into fan socket, then slide scroll end of power assembly into fan housing. Attach by using two sheet metal screws provided. Remove either top or side wiring knockout, depending on wiring direction, by bending it back and forth to break tabs.